Description

A lot of debug adapters cost money that you'd much rather spend on tinkering.  But not the IBDAP - CMSIS-DAP JTAG/SWD Debug Adapter Kit from armstart  - a vendor independent debug interface that works with your PC over USB and targets ARM devices over its JTAG/SWD pins.

Fully supported by most commonly used debugging tools, the IBDAP kit is able to perform debugging functions like stepping, breakpoints, watch points, and firmware downloads.  While debugging's the IBDAP adapter kit's primary use, it can also be used as a general development board with a ARM Cortex M0 processor.

Comes as a fully assembled CMSIS-DAP debugger board, a 2x5-SWD-to-2x10-JTAG adapter and a SWD 2x5 0.05" pitch connector cable.

Features

• NXP LPC11U35FHI33/501 ARM Cortex M0 48Mhz processor
• 64kB Flash 
• 12kB RAM
• 2kB EEPROM
• 1 x USART
• 1 x I2C  
• 2 x SPI
• 1 x USB2.0 
• 8 x ADC(10-bit) 
• 26 x  GPIO
• Supports mbed programming
• IBDAP board dimensions: 27mm x 51mm x 11mm / 1.1" x 2" x 0.4"
• Adapater board dimensions: 24mm x 43mm x 12mm / 0.9" x 1.7" x 0.5"