Qwiic RFID ID-XXLA

Description of product

The Qwiic RFID ID-XXLA is a simple board that pairs with the ID-3LAID-12LAID-20LA, RFID modules. Included with the product is the ID-12LA and three RFID 125Khz cards as a full kit to get you started integrating an I2C RFID solution into your project. Utilizing the onboard ATtiny84A, the Qwiic RFID takes the six byte ID tag of your 125Khz RFID card, attaches a time stamp to it, and puts it onto a stack that holds up to 20 unique RFID scans at any given time. This information is easy to get at with some simple I2C commands and we’ve included some example code that shows you just how to do it using the broken out interrupt pin. We’ve also broken out two antennae pins that should only be used with the smaller ID-3LA.

The Qwiic RFID has a buzzer and LED that indicates that card has been scanned. We’ve included a jumper to disconnect the buzzer, a jumper for the I2C pull-up resistors, an interrupt jumper, and finally an address jumper. The Qwiic RFID comes fully decked out in Qwiic connectors, no need to solder a thing, just plug it in and start scanning!

We do not plan to regularly produce SparkX products so get them while they’re hot!

Experimental Product: SparkX products are rapidly produced to bring you the most cutting edge technology as it becomes available. These products are tested but come with no guarantees. Live technical support is not available for SparkX products. Head on over to our forum for support or to ask a question